hi,
Are you planning to make watkins glen setup for Cup also?

Hiya, I have a setup but it's pre-patch. I'm going to see how it feels with the patch and then post it tomorrow if it's not too bad.

thanks for your replay. looking forward for your post patched setup for watkins glen

I have to make some changes to the setup, and didn't have time today. I'll try to post one tomorrow.

Ok, I just worked on the setup a bit and it feels ok now. I was in the mid-1:12's with it at 80 clear. The car is a bit slippery under heavy acceleration so there's still some work left, but I don't know when I get the chance to work on it further.

As usual,you can get the setup from the downloads section.

thanks for your setup. ill give it a try today and ill tell you what i think about it when i test it

best regards

Download appears to be corrupt on the CUP version (only about 310 bytes).

Greger,

what values did you change for the patched Physics ? I have a pretty much perfect pre-Patch Setup but can't get that damn think to work after the patch. The car is sliding all over the place and has a tendency to understeer horribly (almost like a flat tire) at some times and snap oversteer at others. Also, tire wear has increased considerably. I'm getting frustrated there.

Your Setup is quite good, but i have developed some rather different driving habits at the glen thats why i'd like to transfer my old ( a little more forgiving ) setup over.

Hi Alex

I haven't done many laps on the road courses in Cup cars since the patch, but I remember having those same problems. I didn't find any good ways to fix them. I think softening rear springs and putting in a smaller front sway bar helps a little, but it seems like it's impossible to get the car to handle as well as it did pre-patch without losing too much speed.